Lift and rock the door to get it back on track.
Repair pocket door lock.
Replace the hardware on the door panel.
To begin the process of removing your sliding door from the hardware system you need to open one side of the door.
This will give you good access to.
However you do have to take the latch apart to get to most of the parts that need attention.
Use a 2 6 to check the new track.
Step 5 adjust the new hardware.
A small lock will need to be made bigger.
Attach the rollers to the door.
Lubricating a pocket door lockset is not too hard.
Look for nails through door edges or a stop piece or furring strip nailed across the door opening.
Next use a flashlight to check for broken plaster or other debris inside the door pocket.
Step 10 chisel the mortise for the faceplate.
However if one side of the wall is wallpapered cut through the other side of the wall to save the paper.
Step 8 replace the pocket door pull.
If and only if you are confident the repair can be done that way.
Cut an access hole.
Cut an access hole in the wall with a drywall saw to remove the old track and install a new one.
New track and pocket door rollers.
Drill or cut a 3 to 4 diameter hole at the proper height on the side of the door that allows the best view of the track and hardware.
You can then tip the door to remove it outwards from the bottom of the pocket opening.
Latches and locksets that are sticking or making noise need lubrication.
Floor track doors that refuse to budge may have jumped the track.
To complete the installation replace the entire strike plate or at least the screws.
A step by step guide on how i repaired this pocket door that had come off one of its rollers.
Use the modification tool that is included in the pocket door locks installation kit to make the lock fit properly.
Step 7 repair the wall.
I hope this video empowers the handyman inside you to tackle th.
Lubricating a pocket door lock.
Get free shipping on qualified door repair pocket door hardware products or buy online pick up in store today.
Before you begin lubricating your pocket door latch you want to have a can of lubricant that is suitable for door locks.
Step 6 replace the trim and stops.