Remove Water From Gas Tank Mower

Heet is a fuel additive that is made for removing water from the gas tank.

Remove water from gas tank mower.

If you find yourself in this situation here are some steps you can take to get old gas out of a lawn mower. The principle behind pouring alcohol in the gas tank is as follows. Water forms globules in the gasoline and these are usually visible they look like bubbles. If there s water in the fuel it will bead up.

Place the siphon tube into the gas tank and press the pump to start the gas siphoning. Seal the can after all the gas has been removed from the mower. The best way to remove all water from the gas tank is to drain and refill your gas tank. When alcohol is added to a gas tank with water and gasoline in it the alcohol sinks to the bottom and absorbs the water forming a combination that is no longer harmful to your car s engine.

The gas tank on briggs stratton lawn mower engine is made of a non corrosive or corrosion resistant material to shield it from the deteriorating properties of ethanol salt and water. Remove the water from gas tank. Depending on how much water got into the tank you can use a product like heet that is sold in the automotive section of most stores that helps remove water from fuel. If you aren t sure loosen the fuel line and let a few drops of fuel drip onto a scrap piece of wood or metal.

However if there is more water in the. Move the mower into the shade or bring it indoors and then shine the flashlight into the tank. Direct the used gas into a gas can. Gas that s been in the mower for more than a couple of months can go bad with sediment varnish like contaminants and condensation that can make it difficult to even start the mower again when the time comes.

Water trapped inside a lawnmower will bring it to an immediate standstill. The water gas and alcohol are then burned up and eliminated from the tank. This may seem like an expensive alternative to some drivers.