Remove And Install Garage Doors

Your installer will remove the old door install the new door reconnect your opener and seal the perimeter with new vinyl weather stripping.

Remove and install garage doors.

If no one is available to help a clamp can be put on the track at the end of the door image 1. After your new door is installed remove the old stop material on the outside of the door and replace it with the type that has a rubber weatherstrip gasket available at home centers. If you choose to install a front door made of steel you will need a helper. When it won t move at all you ll know it s in place 2 x research.

Measure both the door and rough opening to make sure the door is the right size. Installing an exterior door that is insulated and made of steel can be heavy and cumbersome due to the weight of the materials. Use their jaws to secure the bottom of the door to the roller track then try to move the door. Remove the bolts only on the top half of each hinge leaving the bottom halves attached to the lower door panel.

It is important to understand that the springs used in opening and closing a garage door support the entire weight of the garage door. Whether it s an interior or exterior door plays a part too. Garage doors weigh 150 pounds or more and if the door were not locked in place there would need to be some way of holding it up until it can be lower manually. You ll need to deal with the lifting mechanisms before you can remove the door 1 x research sourcestep 2 use locking pliers to lock the door in place.

This means that there is extreme tension in these springs and that any sudden and uncontrolled release of these springs is dangerous and could cause serious injuries. The remaining panels and tracks are held in place with hinges brackets and screws. Step 1 lift the garage door as far as it will go. Pick up 2 of them from the home improvement store.

Raise your old door. For doors with torsion springs located over the door spend the 50 or so to have a garage door professional release the tension. This will hold the upper part of the door in place when you remove the 2 by 4 inch prop to get at the center bracket of the lower panel. Attach a couple of vise clamps to the garage door tracks just below the bearings for the second panel.

With a helper or two supporting the top of the top panel remove the roller bracket at each end of the panel. But the good news is our professional independent installers will work with you to find the best door for your needs and one that will fit. Locking pliers are small handheld vice grips. Carefully tilt the panel back and lift it away from the tracks and the rest of the door.

The service provider will also clean up the area and offer a final project walk through before hauling away your old door. Additional fees for haul away may apply in some markets.